Skip to main content
All CollectionsLiveStreaming by Gather
Setting Up Your LiveStream Kit
Setting Up Your LiveStream Kit

This article walks you through the simple process of setting up your LiveStream kit.

Wesley Mowry avatar
Written by Wesley Mowry
Updated over a week ago

Gather's all-in-one, fully-integrated LiveStream solution makes it easy to offer LiveStreaming to your families. The hardware works seamlessly with the software.

The stand’s carrying bag can fit the stand, tablet holder arm, and T-bar. So you only need to grab the LiveStream Kit case and the carrying bag to be ready to start LiveStreaming from any location!

REMEMBER: The camera and iPad are synced to each other for LiveStreaming. We labeled the kit, camera, and iPad so you can keep them together easily. If you have multiple kits and mix up the components, you won’t be able to stream.

Setting up your camera stand

  1. Extend the stand’s telescopic pole to the desired height and tighten the three knobs.

  2. Unfold the tripod legs until they lock in place. The three legs form a sturdy base. If you find the stand unstable, adjust the center pole, so it is not interfering with the legs.

  3. At the top of the stand, screw on the center nut of the T-Bar.

  4. On one of two T-Bar swivels facing up, secure the camera. *

  5. Secure the microphone to the other remaining T-Bar swivel. *

  6. Plug the microphone’s aux cord into the port at the back of the camera. Ensure it’s fully inserted; with the ‘click’.

  7. Press and hold the power button at the back of the camera to turn on the camera. It will make a beeping sound and show the four battery lights. **

    1. You’ll see the SD card installed near the charger port.

*You may need to use the bottom and top knobs of the T-Bar to tighten the camera and microphone to the stand. Ensure that both are pointing directly toward the service. You can use the top knobs to swivel and adjust the vertical angle of each.

**The four small white lights above the power button are the camera’s battery. Fully charged, you can stream for just over 6 hours!

Attaching the Tablet Holder

  1. Loosen the three screws of the Tablet holder and unfold it from the box.

  2. Place the clamp around the stand, just below the middle screw. Tighten the clamp’s knob until secure. There will be a gap between the two sides of the clamp.

  3. Press the two tabs to extend the holder to the width of the iPad.

  4. Rotate the holder so the wide end is at the base.

  5. Place the iPad horizontally into the bottom of the holder and press to top portion down until the iPad is secured.

  6. Adjust the angle of the iPad to how you’d like it. Tighten the two screws to lock that angle.

Indicator light on the front of the camera

Each light corresponds to a different status.

  • White: Turning on

  • Green: Connected to Wifi

  • Red: Ready to LiveStream (and Record)

  • Blue: Ready to Record ONLY

What is included in the shipping box?

  1. Carrying bag

  2. Tripod stand

  3. Tablet holder attachment

  4. T-bar with swivels

  5. LiveStream kit hard case

    1. iPad, with plastic case

    2. Camera

    3. Microphone, with attached AUX cord

    4. Mini SD Card, already inserted into the camera

    5. iPad charger cord

    6. SD card adapter

    7. iPad wall block

    8. Camera wall block

    9. Camera charger cord

The finished product

This is the stand at its most extended height. You can adjust the height of the stand to fit your location and the specific service you’re LiveStreaming.

Need More Help? 👋

Chat with our team anytime. Or give us a ring at (208) 908-0488.

Did this answer your question?